Rle LD2100 Quick Start User Manual download pdf

Mount the Device

THE LD2100 is a panel mounted device. Use the included wall mount kit and

mount the controller in a convenient location.

trademarks of Raymond & Lae Engineering, Inc. The products sold by Raymond & Lae Engineering, Inc. are subject to the limited warranty, limited

liability, and other terms and conditions of sale set forth at http://rletech.com/RLE-Terms-and-Conditions.html.

Installation Supplies

Included with the LD2100

LD2100 controller

Wall mount kit

Crossover cable (blue with yellow ends)

15 foot (4.57m) leader cable

End-of-line terminator (EOL)

Available from RLE, Sold Separately

SeaHawk sensing cable - up to 5,000 feet (1,524m) of conductive uid sensing

cable or 3,500 feet (1,067m) of chemical sensing cable

Optional Enclosure (LD-ENC)

24VAC power supply (WA-AC-24-ST) or 24VDC power supply (PSWA-DC-24-ST)

Network Communications Information

Consult your IT administrator and determine the following LD2100 network

settings:

• IP Address _______________________________________________

• Subnet Mask _____________________________________________

• Default Gateway __________________________________________

SeaHawk LD2100 Quick Start Guide

Thank you for purchasing a SeaHawk LD2100 distance-read leak detection controller.

This guide outlines basic installation and conguration. Additional support information,

including the LD2100 User Guide, is available on our website - www.rletech.com.

If you need further assistance, please contact RLE Technologies at [email protected]

or call us at 800.518.1519.

v1.0

(06/2013)

Test/Reset

Button

LED

Display

Status LED

Install the Sensing Cable

Leader cable is included with the device and is used to connect sensing cable to

the LD2100, since sensing cable cannot connect directly to the controller.

1. Insert the four stripped wires of the leader cable into the

appropriate slots in the 4-pin terminal block connector -

from left to right: white, black, green, and red. Tighten

the screws on the terminal block connector to secure the

leader cable. Thread the leader cable through a knockout

on the bottom of the enclosure and plug the terminal

block connector into TB2.

2. Unscrew the EOL from the end of the leader cable.

3. Attach the rst length of sensing cable to the leader cable.

4. Route the sensing cable according to your cable layout diagram.

5. Secure the EOL to the unoccupied end of the sensing cable.

Apply Power to the LD2100

A dedicated circuit breaker must be provided within

close proximity to the LD2100 and be clearly marked as

the disconnecting device for the LD2100 leak detection

controller.

RLE recommends using a 24VDC wall adapter power supply (PSWA-DC-24-ST),

which is available separately from RLE.

1. Run a power supply to the location of the unit and plug it into P1. If you’re

1 2

Summary of Contents

Page 1 - Apply Power to the LD2100

Mount the DeviceTHE LD2100 is a panel mounted device. Use the included wall mount kit and mount the controller in a convenient location. © Raymond &

Page 2 - Set the LD2100’s IP Address

the network. Remove the crossover cable and properly connect the PC and LD2100 to your network. Type the LD2100’s new IP address in the computer’s b

Comments to this Manuals

No comments

Rle LD2100 Quick Start User Manual

Browse online or download User Manual for Equipment Rle LD2100 Quick Start. RLE LD2100 Quick Start User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Equipment Rle LD2100 Quick Start